New Software for SRT4950H Descramble TANDBERG channels Dated 12 Aug 2016 New Software for SRT4950 H SRT4950HNewGuiDubaiV3.55P12082016 New Software for SRT4950HNewGuiV3.55P12082016 Tandberg channels with New software Down load it: from mediafire: Thanks to Mr. Mosaabsat for his efforts with Mr.Wizkid to produce: this Software. Expert Support, Mr. Mosaabsat Key Codes:. SRT4950SRT4950MNewGuiDubaiV3.55P12082016i.zip New Software for SRT4950 & 4955M Descramble TANDBERG channels Dated 12 Aug 2016 New Software for SRT4950 H New Software for SRT4950SRT4950MDubaiV3.55P12082016 Tandberg channels with New software Now Down load it: from mediafire: Thanks to Mr. Mosaabsat for his efforts with Mr.Wizkid to produce: this Software.
The RTL-SDR samples at 28.8 MHz, thus you may see mirrors of strong signals from 0 – 14.4 MHz while tuning to 14.4 – 28.8 MHz and the other way around as well. To remove these images you need to use a low pass filter for 0 – 14.4 MHz, and a high pass filter for 14.4 – 28.8 MHz, or simply filter your band of interest.
Expert Support, Mr. Mosaabsat Key Codes:. I tested the Strong 4955 firmware and i can confirm there is a Tandberg menu and its working. I can add and use softcam.key to work it.
But there is a problem. When there is a electrical failure or i unplug from the power point, once box starts the tandberg channels wont open. It doesnt Auto start.
I have to plug my usb in and install the softcam.key again to get the tandberg channels working. Powervu and biss all runs fine. Add or Edit keys Manaully - do not use Softcam - Only if Softcam produced from Receiver it self.
Do Factory Reset Check., if not,then it will be corrected in next Software.